Ruger Talk Forums banner
1 - 2 of 2 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
Went to the range this past weekend and had lots of issues with a P95. Bought it used and it looked like it had never been cleaned. Cleaned up once and off to the range. Using WPA and ZVS 115gr FMJs. First couple of mags were fine. Then came the FTE and feed issues. Am guessing a bad extractor or ejector... Or is that Ammo possibly to blame? Couple of times the magazine would unseat as well. Had a new P95 before that had zero issues with any Ammo. I also noticed light primer strikes. Should I just send back to Ruger or try replacing the extractor and firing pin?

Sent from my PG86100 using Ruger Forum mobile app

· Banned
13,094 Posts
Hey Rocky,
Can I suggest, trying different magazines before doing anything else.

Man-o-man, I believe 90% of FTE and feed issues come back to mag problems.
Just an idea

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.