Ruger Talk Forums banner
1 - 1 of 1 Posts

195 Posts
Discussion Starter · #1 · (Edited)
I bought a 1980 Single Six convertible (.22 LR/.22 WRM) with a 6 1/2" barrel and found a really nice leather holster that fits it well, a Hunter model 60.
Well it fits, that is except for requiring me to Dremel grind about 1/4" from the top edge of holster where the rear sight hits it.

The holster's nice leather gets better with a few coats of Biwell wax inside and out.
Snow Seal or Nikwax leather wax also works but do NOT use Neat's-foot oil as it will make the leather stretch too much.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.