Ruger Talk Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
85 Posts
Discussion Starter · #1 ·
I had disassembled my GP 100 per my instructions and jeweled my hammer. I got everything put back together and when I function tested it the trigger would stay back but the hammer would fall. Only every 5 or six times it would do it. I disassembled and reassembled but the same exact thing. I checked the pawl and its not binding up, any suggestions.
 

·
Registered
Joined
·
85 Posts
Discussion Starter · #3 ·
Well after little response here and a lot of searching on the Internet I found out that this problem has happened to quite a few people. It is where either the trigger spring is hanging up or that I need to put the factory spring back in. Still wanting response and I will post when I do this.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top